What repairs cost · Denver, CO
Refrigerator drawer and beverage center repair cost
Parts and labour, fitted
$280–$720
A firm number from inside this range, agreed with you before anything is opened or ordered.
Drawers and beverage centres fall into three of the published bands, $280–$720, and the commonest of them is not a failure at all but a front that has stopped sitting flush. Denver Sub-Zero Repair Pros measures the alignment of a drawer before condemning its seal, because a runner out of true and a hardened gasket produce the same complaint and only one of them is a part.
What the figure covers
- Alignment measured first
- The drawer pulled, the runners checked for level and travel, and the front gauged against its opening — a fault that is mechanical at least as often as it is a seal.
- The seal or the part
- A drawer gasket, a circulation fan or a thermistor, whichever the readings name, in a factory-approved replacement matched to that cabinet.
- The front re-hung and set
- Height, reveal and closing force set together, so the drawer lands flush and the seal is compressed evenly rather than at one corner.
- The compartment proved cold
- Run back to its setting and read on a probe, with the drawer worked several times over, because a fault that only shows after use is the one people live with.
Before any of it
One flat $89 pays for somebody to arrive and read the cabinet properly; approve the repair and that $89 leaves the bill again.
Decline the repair and the visit is the whole of what you have paid. There is no hourly meter and nothing is ordered on an estimate.
What puts a job at the top of the band
- A panelled front that has to be taken off, re-matched to the joinery and set back without marking it
- Two drawers in one stack, where the upper front cannot be set until the lower one is right
What keeps it at the bottom
- A single drawer that comes clear on its slides with room to work in front of the opening
- A fault the first set of readings names, with no joinery to take apart to reach it
Three questions people ask about this one
Why does a drawer frost around the opening?
Because moist room air is getting in and meeting a cold surface. On a drawer that is usually a front sitting proud at one corner, a runner that has dropped, or a seal gone hard enough to stop pulling in. Frost at the opening is the symptom you can see of a gap you cannot.
Do drawers run at the same temperature as the cabinet above them?
Not necessarily, and on some units they are not meant to. Sub-Zero publishes a range of 34 to 45 degrees Fahrenheit for its model 427R refrigerator drawers, which is its own band rather than the one a wine cabinet holds. Check what your model is rated for before deciding a drawer is running warm.
Can a panelled front be refitted without marking the joinery?
That is the whole skill on these. The panel comes off before the drawer does, the fixings go back in the holes they came out of, and the reveal is set against the neighbouring doors rather than by eye. Tell Denver Sub-Zero Repair Pros on (720) 790-9436 that the front is panelled and it is planned for from the start.
Reviews
What Denver owners said afterwards
Built-in Sub-Zero calls, written up by the people who booked them.
4.9/ 5986 reviews
Undercounter unit in a third-floor condo, service elevator only, and I assumed nobody would bother. He came the next morning. Seized compressor relay plus a choked condenser, one trip.
Yusuf K.Cheesman Park
Two weeks without ice, in a building where you cannot simply swap the unit out yourself. He read the fault history, found a dead water valve and a partly blocked screen, and carried both.
Franco G.Cheesman Park
Cubes were shrinking in the bin and everything tasted burnt. He found the drain tube iced solid and a lazy circulation fan. Sorted in one visit.
Lorna D.University Hills
Get this one priced in Denver
On site seven days a week, 8 am to 8 pm across the Denver round. Line picked up 24/7. The diagnosis is $89 and it comes off an approved repair.